How about learning a fun way to use some of your GLITTER!!!
Yes, sometimes you have just the right glitter cardstock for your project, but what do you do when you don’t! Well, you just grab some Multipurpose Adhesive Sheets and get busy.
If you haven’t seen the new Foil Frenzy Specialty Designer Series Paper then cast your eyes on these cards. Sparkly and flashy and then I added the glitter using Multipurpose Adhesive sheets to both side of my Whisper White card stock.
My Big Shot is pretty tight so I used the regular sandwich ran it through and back through to make sure . Then peeled off the front protective barrier and sprinkled my glitter on it, making sure to rub it in very well.
If you don’t have the Adhesive Sheets and the Foil Frenzy Specialty DSP I’m sure you will want to add them to your wish list now 🙂
can watch the creative video below or by CLICKING HERE:
1/8″ Ribbon Gold
Run this through your Big Shot with the Happy Birthday Die. If your Big Shot is loose run it through a couple of times.
Remove the cut out Happy Birthday. Then remove the covering from the adhesive on the top side. DO NOT THROW THIS AWAY AS WE WILL BE USING ON ANOTHER PROJECT 🙂
Use and extra piece of adhesive covering to keep from getting your fingers on the exposed adhesive, this is critical.
Sprinkle Glitter all over the exposed adhesive. Begin rubbing in small circular motion to burnish all the glitter into the adhesive. It will become shinier as you do this.
Remove the back adhesive cover from the Happy Birthday and center on your Night of Navy Card stock.
Using a 8″ piece of 1/8″ gold ribbon, tie in a knot on the front and adhere.
Place the Foil Frenzy on the Soft Suede Card base then the Night of Navy on top of the Foil Frenzy using snail.